If there are objects in Azure AD that were created by another sync engine and these objects aren't in scope, adding filtering doesn't remove them. For example, if you accidentally delete a security group and it was used to ACL a resource, the group and its ACLs can't be recovered.Īzure AD Connect only deletes objects that it has once considered to be in scope. However, you can't undelete other object types. This action restores the users from the recycle bin in Azure AD. Then you can synchronize your directories again. If user objects were inadvertently deleted in Azure AD because of a filtering error, you can recreate the user objects in Azure AD by removing your filtering configurations. If you're on build or later, then the regular full synchronization action also calculates whether passwords should be synchronized and if this extra step is no longer required. For steps on how to trigger a password full sync, see Trigger a full sync of all passwords. If you use a build before November 2015 ( ), make a change to a filter configuration, and use password hash synchronization, then you need to trigger a full sync of all passwords after you've completed the configuration. If you delete many objects due to filtering (500 by default), you need to follow the steps in this article to allow the deletes to go through to Azure AD. To protect you from deleting many objects by accident, the feature " prevent accidental deletes" is on by default. After you've completed the configuration steps, we strongly recommend that you follow the verification steps before you export and make changes to Azure AD. Because of this change, any objects in Azure AD that were previously synchronized but were then filtered are deleted in Azure AD.īefore you start making changes to filtering, make sure that you disable the built-in scheduler so you don't accidentally export changes that you haven't yet verified to be correct.īecause filtering can remove many objects at the same time, you want to make sure that your new filters are correct before you start exporting any changes to Azure AD. If you start with a default configuration of directory synchronization and then configure filtering, the objects that are filtered out are no longer synchronized to Azure AD. In Azure AD Connect sync, you can enable filtering at any time. As a result, Microsoft can't provide technical support for such deployments. Any of these actions might result in an inconsistent or unsupported state of Azure AD Connect sync. Microsoft doesn't support modifying or operating Azure AD Connect sync outside of the actions that are formally documented. This article covers how to configure the different filtering methods. But in Azure AD, you only want active accounts to be present. For compliance reasons, you don't delete any user accounts on-premises.You have many service accounts and other nonpersonal accounts that you don't want in Azure AD.In the small pilot, it's not important to have a complete Global Address List to demonstrate the functionality. You run a pilot for Azure or Microsoft 365 and you only want a subset of users in Azure AD.In some cases however, you're required to make some changes to the default configuration. With the default configuration, they would have the same experience that they would have with an on-premises implementation of Exchange or Lync. Users using Microsoft 365 workloads, such as Exchange Online and Skype for Business, benefit from a complete Global Address List so they can send email and call everyone. In general, this is the recommended configuration. The default configuration takes all objects in all domains in the configured forests. By using filtering, you can control which objects appear in Azure Active Directory (Azure AD) from your on-premises directory.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |